Static Load Analysis Of Tata Ace Ex Chassis And Stress Optimisation Using Reinforcement Technique

Sandip Godse; Prof. D.A.Patel

doi:https://doi.org/10.14445/22315381/IJETT-V4I7P151

Research Article | Open Access | Download PDF

Volume 4 | Issue 7 | Year 2013 | Article Id. IJETT-V4I7P151 | DOI : https://doi.org/10.14445/22315381/IJETT-V4I7P151

Static Load Analysis Of Tata Ace Ex Chassis And Stress Optimisation Using Reinforcement Technique

Sandip Godse , Prof. D.A.Patel

Citation :

Sandip Godse , Prof. D.A.Patel, "Static Load Analysis Of Tata Ace Ex Chassis And Stress Optimisation Using Reinforcement Technique," International Journal of Engineering Trends and Technology (IJETT), vol. 4, no. 7, pp. 3037-3039, 2013. Crossref, https://doi.org/10.14445/22315381/IJETT-V4I7P151

Abstract

Chassis is a major component in a vehicle system. This work involved static analysis to determine key characteristics of a chassis. The static characteristics include identifying location of high stress area. Mathematical calculations were carried out to validate the static analysis . This paper presents the static load analysis of the chassis of TATA ace ex using ANSYS workbench and stress optimization using reinforcement technique of optimization . This has been carried out with limited modifications by adding stiffeners. The necessary design changes required to enhance the load carrying capacity of the veh icle has been recommended successfully.

Keywords

ANSYS, FEM, TATA,

References

[1] Cicek Karaoglu , N. Sefa Kuralay “ Stress analysis of a truck chassis with riveted joints ” Finite Elements in Analysis and Design 38 (2002) 1115 – 1130, Department of Mechanical Engineering, DEU Faculty of Engineering, 35100 Bornova, Izmir, Turkey.
[2] Mohd Azizi Muhammad Nora,b, Helmi Rashida, Wan Mohd Faizul Wan Mahyuddinb,Mohd Azuan Mohd Azlanc, Jamaluddin Mahmuda, “ Stress Analysis of a Low Loader Chassis ” International Symposium on Robotics and Intelligent Sensors 2012, a Faculty of Mechanical Engineering, Universiti Teknologi MARA, Shah Alam 40450, Malaysia.
[3] O Kurdi, R Abd - Rahman, M N Tamin, “ Stress Analysis Of Heavy Duty Truck Chassis Using Finite Element Method ” Faculty of Mechanical Engineering Universiti Teknologi Malaysia 81310 UTM Skudai, Johor.
[4] Dr.R.Rajappan, M.Vivekanandhan, “ Static and Modal Analysis of Chassis by Using Fea ” The International Journal Of Engineering And Science (Ijes) Volume 2, ssue 2,Page 63 - 73 (2013)
[5] Sairam Kotari, V.Gopinath, “ Static and dynamic analysis on tatra chassis ” International Journal of Modern Engineering Research (IJMER), Vol.2, Issue.1, pp - 08 6 - 094